Utility Menu

Powder/Bulk Solids

The Source for Dry Processing and Bulk Handling Technology

Featured Equipment

  • High-Capacity Cone Mill for Sticky, Moist, Fragile Materials

    A new 29.5-in.-diam CGM 750 cone mill gently grinds fatty, heat-sensitive, sticky, moist, or fragile materials into uniform particle sizes with minimal fines, at rates to 35 tn/hr. Vertical material flow and low-energy grinding action with short residence times yield close particle size...

  • Powder Wetting in Batch Processes

    The CMX 2000 inline mixer incorporates powders into liquids and mixes these materials reliably and consistently in a batch process. Its multi-level design and unique pumping stage enables processing of high-viscosity products without any additional aggregates. This enables extreme suction...

  • ASGCO Offers Pit-Skalper Belt Cleaner

    The Pit-Skalper is based on the proven technology and performance of the Skalper, which is used throughout the world in the harshest environments. This new design is specifically geared to handle the needs of aggregate, ready mix, portable crushing and screening plants, sand, gravel, asphalt, and...

  • Stainless Steel Hopper Feeder for Food Applications

    The Model HFE-830-7-1/2-(3) vibratory hopper feeder from Best Process Solutions features an 8 X 30 in. flat trough and 3-cu-ft-capacity hopper. The unit is manufactured to FDA food-grade standards. The entire trough fame and hopper supports are fabricated from 304 polished stainless. Typical...

  • Wet Dust Collectors

    Whirl Wet dust collectors combine high efficiencies (99% efficiency range for a broad variety of applications) with the ability to install virtually anywhere in a plant environment without explosion suppression.  Whirl Wets collect soluble and insoluble particulate using minimal water. Units...

  • Identifying a Pin Mill for Optimal Performance and Minimal Downtime

    A pin mill reduces dry bulk materials to medium fineness by impact — that is, by hitting or striking particles with high energy to break them. As with any impact mill, the pin mill’s components and surfaces are exposed to high wear and a challenging operating environment. The best way...

  • Tech Talk: Hammer Mills and the Attrition Zone

    Traditional hammer mills work on the principle that most materials will crush, shatter, or pulverize upon impact. Material is fed into the mill’s chamber through the feed chute, and struck by ganged hammers, which are attached to a shaft that rotates at high speed inside the mill’s...

  • Customized Lump Breaker Solves Process Line Challenges

    A North American manufacturer was looking to reduce material handling and operator fatigue, while maintaining consistency of product on an existing production line. In the current process, an ingredient was encapsulated into a heated liquid by filling a series of large and heavy square rubber trays...

  • Thermal Blender for Heating Bulk Solids

    Heating bulk solids can pose a significant challenge to process engineers. Often the material itself is a poor thermal conductor, and excessive heat may be applied, which risks damaging the material. Ajax Equipment has found a solution to the problem. By applying its cascade mixing technology, Ajax...

  • Kice Introduces New Line of Replacement Filter Bags

    Kice Industries has introduced a new line of replacement filter bags that are more efficient and offer a longer bag life than previous versions. “These DuraTes bags allow less penetration of the media and promotes more surface loading, resulting in longer media life,” said Jeff Kice,...

Pages